1、開啟總電源
1. Turn on the main power supply.
2、按玻璃厚度調整上風刀位置(干燥段四個手柄)
2. Adjust the position of the upper blade according to the thickness of the glass (four handles in the drying section).
3、在每班生產之前15分鐘開動鼓風機(控制臺)
3. Start the blower (console) 15 minutes before each shift.
4、檢查水箱是否注滿水
4, check whether the water tank is filled with water.
5、開啟水泵(控制臺)
5. Turn on the pump (console).
6、給海綿輥?zhàn)⑺?，使其膨脹，然后停止注?br /> 6. Pour water into the sponge roller to make it expand and then stop flooding.
7、設定熱風溫度(控制臺)
7. Set the hot air temperature (console).
8、加熱器通電(控制臺)
8. Heater power (console)
9、開動毛刷輥電機(控制臺)
9. Start the brush roller motor (console).
10、將玻璃板放在進料段限位范圍內

10. Put the glass plate in the limit of feed section.

11、開檢查照明燈(控制臺)
11. Turn on the check light (console).
12、在出料段處檢查玻璃并取走
12. Check the glass at the discharging section and take it away.
13、每班生產結束時先關加熱器，三分鐘后關掉鼓風機(控制臺)
13. Turn off the heater at the end of each shift and turn off the blower (console) in three minutes.
14、關照明燈(控制臺)
14, care for lights (console)
15、關毛刷輥電機(控制臺)
15. Turn off brush roller motor (console)
16、將速度調節器降至最低位置(控制臺)
16. Reduce the speed regulator to the lowest position (console).
17、關傳送輥電機(控制臺)
17. Turn off the conveyor motor (console).
18、關水泵
18. Turn off the pump.
19、關總電源
19, turn off the total power supply.
本文由移門生產設備整理發布，您是不是對這些內容有所了解了呢?更多的內容請點擊：http://hnyfqpj.cn我們會有更多精彩內容等你查看。
This article is published by Moving Door Manufacturing Equipment. Do you know something about it? For more information, please click: http://hnyfqpj.cn. We will have more exciting content for you to see.